Installation Guide
Table Of Contents
- About This Guide
- Access Points
- Installing AP300
- Safety Precautions
- Best Practices for an AP300/AP1000 Network
- Unpack the AP300
- Determine Power Requirements
- Installation Requirements
- Install the AP300
- Select a Location
- Attach the Provided Antennas
- Install the Remote Antenna Mount (optional)
- Install External ACC-ANT-MIMO-MNT Antenna with Three Connectors (optional)
- Install Remote ACC-ANT-6ABGN-24 Antenna with Six Connectors (optional)
- Install Antennas With One Connector (optional)
- Install the Access Point
- Check AP300 LED Activity
- Where to Go From Here
- Installing AP320i
- Installing AP332e
- Installing AP332i
- Cautions and Warnings
- Regulatory Information
- Supported PoEs
- Optional External Antennas
© 2012 Meru Networks, Inc. Optional External Antennas 99
Appendix D
Optional External Antennas
This appendix provides quick overviews regarding several external antennas that are
supported in conjunction with AP300 models. Each model provides brief instructions
on antenna installation.
ACC-ANT-ABGN-23
Suspended-ceiling mounting clips are provided on the rear panel of the antenna
package. Make two small slots in the tile to pass the feedlines, then install the
antenna on the tile-support rail, as shown in Figure 52.
Figure 52: Basic I-Beam Installation
For installations using recessed-edge tiles, use the supplied plastic recessed tile
adapter clips. Snap clips onto the ceiling-tile grid then mount the antenna to the
clips, as shown in Figure 53.