Installation Guide

38 Meru Access Point Installation Guide © 2012 Meru Networks, Inc.
Installing AP320i
Install the Access Point
The AP320i ships with a detachable ceiling mounting bracket, making the unit ready for ceiling
mounting. You can also use the included wall-mount bracket by attaching it to the default ceiling-
mount one that comes already attached. Installation directions are provided below.
Mount AP320i in any of the following ways:
 Mount AP320i Below a Suspended Ceiling
 Mount AP320i Above a Suspended Ceiling
 Mount AP320i Vertically on a Wall
 Set AP320i on a Shelf
Mount AP320i Below a Suspended Ceiling
AP320i ships ready to mount on a suspended ceiling; the attached bracket clips to a ceiling rail.
To mount an AP320i below a suspended ceiling, follow these steps:
1. Determine the location on the ceiling rail where the AP will be mounted and remove the ceiling
tiles.
2. Align the mounting bracket with the slots indicated in Figure 15 below.
Figure 15: Install AP320i Below a Suspended Ceiling
3. Press down on the tab indicated in Figure 15 and rotate the AP320i into place. Note that depending
on the date on which the AP was shipped, there may be two tabs on the underside (as shown above).
T-bar
(in ceiling)
Mounting bracket Press this tab down
with T-bar.
AP300i
00235