Installation Guide
Table Of Contents
- About This Guide
- Access Points
- Installing AP300
- Safety Precautions
- Best Practices for an AP300/AP1000 Network
- Unpack the AP300
- Determine Power Requirements
- Installation Requirements
- Install the AP300
- Select a Location
- Attach the Provided Antennas
- Install the Remote Antenna Mount (optional)
- Install External ACC-ANT-MIMO-MNT Antenna with Three Connectors (optional)
- Install Remote ACC-ANT-6ABGN-24 Antenna with Six Connectors (optional)
- Install Antennas With One Connector (optional)
- Install the Access Point
- Check AP300 LED Activity
- Where to Go From Here
- Installing AP320i
- Installing AP332e
- Installing AP332i
- Cautions and Warnings
- Regulatory Information
- Supported PoEs
- Optional External Antennas
Installing AP320i
© 2012 Meru Networks, Inc. Installing AP320i 43
Figure 21: Rotate AP320i into Place on the Recessed Ceiling Rail
4. Attach the bracket shown in Figure 22 to the ceiling rail. Loosen the two screws enough to slip the
ceiling rail into the channel and then tighten the screws.
Figure 22: Tighten the Brackets to Fit the T-Bar
Mount AP320i on an Interlude/Silhouette T-Bar
The optional mounting kit for ceilings with Interlude / Silhouette T-bar (ACC-MNT-SCRMKIT-04) allows
the AP320i (as of Revision N) to attach to this type of ceiling by extending the distance from the ceiling
rail to the AP. See Figure 23.
Note:
Figure 21 depicts ACC-MNT-SCRMKIT-02 being used. This same procedure is
used for ACC-MNT-SCRMKIT-03 as well.
00253
Adjust to fit ceiling T-bar,
by pressing on thumbscrew
T-bar
(in ceiling)
Mounting bracket
Adjustable bracket
AP300i
00256