Installation Guide
Table Of Contents
- About This Guide
- Access Points
- Installing AP300
- Safety Precautions
- Best Practices for an AP300/AP1000 Network
- Unpack the AP300
- Determine Power Requirements
- Installation Requirements
- Install the AP300
- Select a Location
- Attach the Provided Antennas
- Install the Remote Antenna Mount (optional)
- Install External ACC-ANT-MIMO-MNT Antenna with Three Connectors (optional)
- Install Remote ACC-ANT-6ABGN-24 Antenna with Six Connectors (optional)
- Install Antennas With One Connector (optional)
- Install the Access Point
- Check AP300 LED Activity
- Where to Go From Here
- Installing AP320i
- Installing AP332e
- Installing AP332i
- Cautions and Warnings
- Regulatory Information
- Supported PoEs
- Optional External Antennas
Installing AP320i
© 2012 Meru Networks, Inc. Installing AP320i 49
Figure 30: AP320i Ethernet Port on the Right
7. If you are not using a PoE device, connect an external power supply to the power connector and
plug it into the wall.
8. Using the three screws on the underside of the AP320i mounting bracket (inserted in Step 1 earlier),
align the AP with the wall mount bracket. Refer to Figure 31.
Figure 31: Wall Mount Bracket Alignment Holes
9. Press the AP into place and slide it downwards to lock the screws into their corresponding holes.
10. Optionally, lock the brackets together with a small lock by running it through the two holes that
lined up towards the top-left or bottom-right sides of the bracket.
g00240
LAN 5V DCCON
console Ethernet