Installation Guide
Table Of Contents
- About This Guide
- Access Points
- Installing AP300
- Safety Precautions
- Best Practices for an AP300/AP1000 Network
- Unpack the AP300
- Determine Power Requirements
- Installation Requirements
- Install the AP300
- Select a Location
- Attach the Provided Antennas
- Install the Remote Antenna Mount (optional)
- Install External ACC-ANT-MIMO-MNT Antenna with Three Connectors (optional)
- Install Remote ACC-ANT-6ABGN-24 Antenna with Six Connectors (optional)
- Install Antennas With One Connector (optional)
- Install the Access Point
- Check AP300 LED Activity
- Where to Go From Here
- Installing AP320i
- Installing AP332e
- Installing AP332i
- Cautions and Warnings
- Regulatory Information
- Supported PoEs
- Optional External Antennas
Check AP320i LED Activity
© 2012 Meru Networks, Inc. Installing AP320i 51
Check AP320i LED Activity
When AP320i first connects to the controller (and any time the access point is rebooted), the AP initial-
izes and then is programmed by the controller. When the AP first powers up, all LEDs are green. There-
after, the Status LED color reflects the various operating states.
Figure 33: AP320i Status LEDs
After the AP320i is connected, check the status of the LEDs. The functions of the five LEDs are
described below.
00239
power status LAN Radio 1 Radio 2