Installation Guide
Table Of Contents
- About This Guide
- Access Points
- Installing AP300
- Safety Precautions
- Best Practices for an AP300/AP1000 Network
- Unpack the AP300
- Determine Power Requirements
- Installation Requirements
- Install the AP300
- Select a Location
- Attach the Provided Antennas
- Install the Remote Antenna Mount (optional)
- Install External ACC-ANT-MIMO-MNT Antenna with Three Connectors (optional)
- Install Remote ACC-ANT-6ABGN-24 Antenna with Six Connectors (optional)
- Install Antennas With One Connector (optional)
- Install the Access Point
- Check AP300 LED Activity
- Where to Go From Here
- Installing AP320i
- Installing AP332e
- Installing AP332i
- Cautions and Warnings
- Regulatory Information
- Supported PoEs
- Optional External Antennas
Safety Precautions
© 2012 Meru Networks, Inc. Installing AP332e 55
Chapter 4
Installing AP332e
This chapter describes how to install and configure an AP332e. It contains the following sections:
Safety Precautions
Unpack the AP332e
Installation Requirements
Install the AP332e
Check AP332e LED Activity
Where to Go From Here
Safety Precautions
IMPORTANT—Read and follow the regulatory instructions in Appendix B before installing and operating
this product.
If an optional power supply is used, it must be one supplied by Meru Networks.
The AP332e is intended only for installation in Environment A as defined in IEEE 802.3af. All intercon-
nected equipment must be contained within the same building, including the interconnected equip-
ment's associated LAN connection.
Unpack the AP332e
Confirm that the AP332e shipping package contains these items:
Warning!
This product is intended to be supplied by a UL Listed power supply
marked Class 2 or LPS and rated minimum 12Vdc, 2A. For Power over
Ethernet, an 802.3at connection must be used.