Installation Guide

Table Of Contents

Install the AP332e

4. Connect one end of the CAT5 (or greater) Ethernet cable with PoE to the 100/1000 Ethernet

connector on the underside of the AP.

5. Verify that the AP comes online and then replace the ceiling tiles removed in Step 1.

Mount AP332e on a Dropped Ceiling Bevel Tile

The mounting procedure for a ceiling that has recessed supports and lowered tiles is similar to that of

mounting on a suspended ceiling. However, this procedure requires a specialized mounting bracket

(ACC-MNT-SCRMKIT-03), as shown in Figure 38.

Figure 38: Dropped Bevel Tile Mounting Bracket

1. Remove the ceiling tile alongside which the AP will be mounted.

2. Locate the 650-00232 15/16" T-Bar Adapter/Wall Mount and attach the AP to the mounting

bracket by pressing the bracket’s Mounting Pins (shown in Figure 37) to the AP’s Receiving Slots and

sliding the bracket until it locks in place.

3. Push down on the thumbscrews provided on the mounting bracket and clip it to the ceiling bar that

will support the AP.

4. Tighten the screws to ensure that the mechanism stays locked in place.

5. Gently press the underside of the AP (with bracket attached) against the Dropped Bevel Tile

Mounting bracket indicated above and twist to lock them together.

6. Connect one end of the CAT5 (or greater) Ethernet cable with PoE to the 100/1000 Ethernet

connector on the underside of the AP.

7. Verify that the AP comes online and then replace the ceiling tiles removed in Step 1.