User's Manual
Table Of Contents
- Meru Networks AP822 Installation Guide
- 1 About AP822
- 2 Installing AP822eV2
- 3 Installing AP822iV2
- 4 AP822 Mounting
- Horizontally on a Shelf
- Vertically on a Wall
- Installation
- Removal
- Box Mount
- Below a Standard Suspended Ceiling
- AP Installation over Standard 9/16” or 15/16” T-Bar
- AP Removal from Standard 9/16” or 15/16” T-Bar
- AP Installation over Interlude & Silhouette T-Bars
- AP Removal from Interlude & Silhouette T-Bar
- Above a Standard Suspended Ceiling
- LED Lights
- Next Steps
- 5 Approved Antennas
- Wall Mount AP832e Antenna Orientation
- A Regulatory Information
- Regulatory Specifications
- Declaration of Conformity, Federal Communication Commission
- Declaration of Conformity, Industry Canada
- Declaration of Conformity, R&TTE Directive 1999/5/EC
- VCCI Statement
- General Information of RF Exposure
- B Additional Notes
- Maximum EIRP
- Dual Concurrent Same Band Operation
- Manufacturing Information
- Distributed Antenna Systems (DAS)
- Air Handling Space Requirements
- Frequencies Blocked for Regulatory Compliance
- Restriction of Hazardous Substances
- C Cautions and Warnings
- Cautions
- Warnings
21
4 AP822 Mounting
AP822 ships with several different mounting bracket components that allow for a variety of
mounting options. You can mount an AP822 in any of the following ways:
You can mount an AP822 in any of the following ways:
• “Horizontally on a Shelf” on page 21
• “Vertically on a Wall” on page 22
• “Box Mount” on page 26
• “Below a Standard Suspended Ceiling” on page 27
• “Above a Standard Suspended Ceiling” on page 33
Horizontally on a Shelf
When mounting an AP822 horizontally, place it on the desired surface and connect the power
and network cables (G1 Ethernet Port is also used a PoE input). Optional stands (MNT-FEET-
SET-X5) can be applied underneath to raise AP822 for additional cabling space.
Read and follow the regulatory instructions in Appendix A before installing and operating AP822.