User's Manual
Table Of Contents
- Meru Networks AP822 Installation Guide
- 1 About AP822
- 2 Installing AP822eV2
- 3 Installing AP822iV2
- 4 AP822 Mounting
- Horizontally on a Shelf
- Vertically on a Wall
- Installation
- Removal
- Box Mount
- Below a Standard Suspended Ceiling
- AP Installation over Standard 9/16” or 15/16” T-Bar
- AP Removal from Standard 9/16” or 15/16” T-Bar
- AP Installation over Interlude & Silhouette T-Bars
- AP Removal from Interlude & Silhouette T-Bar
- Above a Standard Suspended Ceiling
- LED Lights
- Next Steps
- 5 Approved Antennas
- Wall Mount AP832e Antenna Orientation
- A Regulatory Information
- Regulatory Specifications
- Declaration of Conformity, Federal Communication Commission
- Declaration of Conformity, Industry Canada
- Declaration of Conformity, R&TTE Directive 1999/5/EC
- VCCI Statement
- General Information of RF Exposure
- B Additional Notes
- Maximum EIRP
- Dual Concurrent Same Band Operation
- Manufacturing Information
- Distributed Antenna Systems (DAS)
- Air Handling Space Requirements
- Frequencies Blocked for Regulatory Compliance
- Restriction of Hazardous Substances
- C Cautions and Warnings
- Cautions
- Warnings
25
Figure 7: Attaching the AP to the Wall Mount
11.The Meru logo on the front of the AP should face up and be readable. The ports on the AP
should be in line with the cable cutout on the wall mount bracket.
12.Make any necessary cable connections at this time (Ethernet, power, locking cable).
13.Carefully position the AP over the adapter bracket pins and slide the AP gently from left to
right until the locking mechanism “clicks” into place. Verify that the locking mechanism is
securely locked into place to prevent accidental disengagement and potential damage, if
dropped.
14.Verify that the AP comes online.
Figure 5 shows an AP822iV2 model being attached to the bracket, but the process is identical for either
AP.