User's Manual
Table Of Contents
- Meru Networks AP822 Installation Guide
- 1 About AP822
- 2 Installing AP822eV2
- 3 Installing AP822iV2
- 4 AP822 Mounting
- Horizontally on a Shelf
- Vertically on a Wall
- Installation
- Removal
- Box Mount
- Below a Standard Suspended Ceiling
- AP Installation over Standard 9/16” or 15/16” T-Bar
- AP Removal from Standard 9/16” or 15/16” T-Bar
- AP Installation over Interlude & Silhouette T-Bars
- AP Removal from Interlude & Silhouette T-Bar
- Above a Standard Suspended Ceiling
- LED Lights
- Next Steps
- 5 Approved Antennas
- Wall Mount AP832e Antenna Orientation
- A Regulatory Information
- Regulatory Specifications
- Declaration of Conformity, Federal Communication Commission
- Declaration of Conformity, Industry Canada
- Declaration of Conformity, R&TTE Directive 1999/5/EC
- VCCI Statement
- General Information of RF Exposure
- B Additional Notes
- Maximum EIRP
- Dual Concurrent Same Band Operation
- Manufacturing Information
- Distributed Antenna Systems (DAS)
- Air Handling Space Requirements
- Frequencies Blocked for Regulatory Compliance
- Restriction of Hazardous Substances
- C Cautions and Warnings
- Cautions
- Warnings
Wall Mount AP832e Antenna Orientation40
Option 1Vertical Antenna Orientation (90 degrees to AP)
Figure 12: Vertical Antenna Orientation
Option 1 is recommended where the maximum coverage is required towards the sides of the
AP and the minimum coverage in front of the AP as shown in Figure 1. Example: Mounting the
AP at the middle of the corridor wall where the maximum coverage is required on both sides of
the AP.