User's Manual
Table Of Contents
- Meru Networks AP822 Installation Guide
- 1 About AP822
- 2 Installing AP822eV2
- 3 Installing AP822iV2
- 4 AP822 Mounting
- Horizontally on a Shelf
- Vertically on a Wall
- Installation
- Removal
- Box Mount
- Below a Standard Suspended Ceiling
- AP Installation over Standard 9/16” or 15/16” T-Bar
- AP Removal from Standard 9/16” or 15/16” T-Bar
- AP Installation over Interlude & Silhouette T-Bars
- AP Removal from Interlude & Silhouette T-Bar
- Above a Standard Suspended Ceiling
- LED Lights
- Next Steps
- 5 Approved Antennas
- Wall Mount AP832e Antenna Orientation
- A Regulatory Information
- Regulatory Specifications
- Declaration of Conformity, Federal Communication Commission
- Declaration of Conformity, Industry Canada
- Declaration of Conformity, R&TTE Directive 1999/5/EC
- VCCI Statement
- General Information of RF Exposure
- B Additional Notes
- Maximum EIRP
- Dual Concurrent Same Band Operation
- Manufacturing Information
- Distributed Antenna Systems (DAS)
- Air Handling Space Requirements
- Frequencies Blocked for Regulatory Compliance
- Restriction of Hazardous Substances
- C Cautions and Warnings
- Cautions
- Warnings
Wall Mount AP832e Antenna Orientation 41
Option 2 Horizontal Antenna Orientation
Figure 13: Horizontal Antenna Orientation
Figure 14: Horizonta Antenna Orientation (Side View)
Option 2, horizontal antenna orientation is recommended where the maximum coverage is
required in front of the AP and the minimum coverage is required towards the sides of the AP
as shown in Figure 3.
Example: Mounting the AP on the end wall of the corridor where the maximum coverage is
required in front of the AP.