User's Manual
Table Of Contents
- Meru Networks AP822 Installation Guide
- 1 About AP822
- 2 Installing AP822eV2
- 3 Installing AP822iV2
- 4 AP822 Mounting
- Horizontally on a Shelf
- Vertically on a Wall
- Installation
- Removal
- Box Mount
- Below a Standard Suspended Ceiling
- AP Installation over Standard 9/16” or 15/16” T-Bar
- AP Removal from Standard 9/16” or 15/16” T-Bar
- AP Installation over Interlude & Silhouette T-Bars
- AP Removal from Interlude & Silhouette T-Bar
- Above a Standard Suspended Ceiling
- LED Lights
- Next Steps
- 5 Approved Antennas
- Wall Mount AP832e Antenna Orientation
- A Regulatory Information
- Regulatory Specifications
- Declaration of Conformity, Federal Communication Commission
- Declaration of Conformity, Industry Canada
- Declaration of Conformity, R&TTE Directive 1999/5/EC
- VCCI Statement
- General Information of RF Exposure
- B Additional Notes
- Maximum EIRP
- Dual Concurrent Same Band Operation
- Manufacturing Information
- Distributed Antenna Systems (DAS)
- Air Handling Space Requirements
- Frequencies Blocked for Regulatory Compliance
- Restriction of Hazardous Substances
- C Cautions and Warnings
- Cautions
- Warnings
General Information of RF Exposure52
least a minimum distance as specified from the user in accordance to the regulatory guide-
lines which are designed to reduce the overall exposure of the user or operator.
The World Health Organization has stated that present scientific information does not indicate
the need for any special precautions for the use of wireless devices. They recommend that if
you are interested in further reducing your exposure then you can easily do so by reorienting
antennas away from the user or placing he antennas at a greater separation distance then
recommended.
FCC Guidelines
This device meets FCC guidelines for exposure to radio waves.
The AP822eV2 and AP822iV2 include radio transmitters and receivers. It is designed not to
exceed the limits for exposure to radio waves (radio frequency electromagnetic fields) as ref-
erenced in FCC Part 1.1310. The guidelines are based on IEEE ANSI C 95.1 (92) and include
a substantial safety margin designed to ensure the safety of all persons, regardless of age and
health.
As such the systems are designed to be operated as to avoid contact with the antennas by the
end user. It is recommended to set the system in a location where the antennas can remain at
least a minimum distance as specified from the user in accordance to the regulatory guide-
lines which are designed to reduce the overall exposure of the user or operator.
The device has been tested and found compliant with the applicable regulations as part of the
radio certification process.
Separation Distance
MPE Distance Limit
0.82 mW/cm2 25 cm (9.84 inches) 1.00 mW/cm2