Specifications

Source Organization：
：：
：
USI CVS2/RD2/NS
DOC NO.:
Original Effective Date：
：：
：
01-09-2014
AP832e / AP832i /AP822e /AP822i
Hardware
Specification
PAGE
8 OF 10
maximum configuration.
• Support for 12V DC power supplied externally via optional country specific AC to DC
adapter kits. The maximum load on DC input must be no more than 15.5W. The 12V
DC adaptors must be compatible with 1.65mm DC jack.
• The design must allow PoE and DC co-existent, but providing power redundancy is
not required.
• The design must provide a GPIO indicating the power source, either DC or PoE and
another GPIO indicating the PoE power source, either 802.3at or 802.3af.
• Within the power budget, 12.95W of 802.3af, the design must be able to power up the
full system in the configuration of two 3x3 3-stream Radios (both in 5GHz with 80MHz
channel bandwidth), the USB with 500mA-disabled, the LAN w/ PoE ( G1)port served
as the uplink port and the other LAN port (G2)with traffic in worst case, CPU operated
at 800MHz, and DDR3 operated at 667MT/s.
• Within the power budget, 25.5W of 802.3at, the design must be able to power up the
full system for all the interfaces in the configuration of two 3x3 3-stream Radios (both
in 5GHz with 80MHz channel bandwidth), the USB with 500mA enabled, the “G1” port
served as the uplink port and the “G2” port with traffic in worst case, CPU operated at
800MHz, and DDR3 operated at 667MT/s.
• The design and the DC adaptor must be able to power up the full system for all the
interfaces in the configuration of two 3x3 3-stream Radios (both in 5GHz with 80MHz
channel bandwidth), the USB with 500mA-enabled, the “G1” port served as the uplink
port and the “G2” port with traffic in worst case, CPU operated at 800MHz, and DDR3
operated at 667MT/s.
3.3.16 Physical Dimensions
• The Main Board must be exactly the same as AP332’s in dimension, all mounting hole
locations, all IO port’s locations, both radio card locations, and the locations of CPU,
both Ethernet PHYs, and DDR3 memory to leverage the enclosure design of AP332
completely.
• AP332 dimension: Can’t be larger than 5.75” x 5.75”, and must fully enclose both
miniPCIe radio cards. Both Ethernet RJ45 connectors, USB type-A connector, DC jack,
and Configuration Restored-to-Defaults Button, all should be top-entry type to allow
access from the bottom enclosure for either non-metallic enclosure for internal
antennas or metallic enclosure for external antennas.
3.3.17 Environmental Requirements
• Operating temperature: 0 to +50°C for indoor