User's Manual
Table Of Contents
- Meru Networks AP822v2 Installation Guide
- 1 About AP822
- 2 Installing AP822eV2
- 3 Installing AP822iV2 and XP8i
- 4 Mounting AP822 and XP8i
- 5 Approved Antennas
- Wall Mount AP822e Antenna Orientation
- A Regulatory Information
- Regulatory Specifications
- Declaration of Conformity, Federal Communication Commission
- Declaration of Conformity, Industry Canada
- Declaration of Conformity, R&TTE Directive 1999/5/EC
- VCCI Statement
- General Information of RF Exposure
- B Additional Notes
- Maximum EIRP
- Dual Concurrent Same Band Operation
- Manufacturing Information
- Distributed Antenna Systems (DAS)
- Air Handling Space Requirements
- Frequencies Blocked for Regulatory Compliance
- Restriction of Hazardous Substances
- C Cautions and Warnings
- Cautions
- Warnings
Features12
Detail Info: 'upgrade to 6.1-3 or above'
Web UI will also display Critical Alarm
Features
IEEE Std 802.11ac in AP822
The AP822 series is the first of Meru access point family capable of operating in the IEEE Std
802.11ac mode, which is capable for theoretical throughput rates up to 866 Mbps per radio.
IEEE Std 802.11ac is applied only on the 5 GHz band, and its higher throughput levels require
the use of 80 MHz wide channels.
TABLE 2: AP822v2 Feature List
AP822iV2 and XP8i AP822eV2
Two dual-band-selectable radios, in either
2.4 GHz or 5.x GHz, capable of operating
in IEEE 802.11b/g/a/n and IEEE 802.11ac
standards, with INTERNAL
antennas.
Two dual-band-selectable radios, in either
2.4 GHz or 5.x GHz, capable of operating
in IEEE 802.11b/g/a/n and IEEE 802.11ac
standards, with optional EXTERNAL
antennas.
Supported by System Director versions 6.1 and greater.
Supports 80-MHz channel-bonding (VHT80) in 5.x GHz band with IEEE Std 802.11ac. 80-
MHz channel-bonding (VHT80) combines four 20-MHz channels into a single 80-MHz
channels for increasing bandwidth.
Supports Plug and Play deployment.
Supports multi-layered security including Enterprise WPA2 features such as automatic
traffic inspection.
Powered by either a standard IEEE 802.3af or IEEE 802.3at PoE switches or PoE injec-
tors. Supports an optional 12v external power adapter.
Supports channel span architecture that requires no channel planning or configuration.
Supports wired stations via the secondary Ethernet interface.
Provides pre-pack PHY data rate up to 866 Mbps per radio at IEEE Std 802.11ac with
MCS9/QAM-256 mode.
AP 822 V2 POE is supported only on port G1. Connect the POE connector to G1 port.