User's Manual
Table Of Contents
- Meru Networks AP822v2 Installation Guide
- 1 About AP822
- 2 Installing AP822eV2
- 3 Installing AP822iV2 and XP8i
- 4 Mounting AP822 and XP8i
- 5 Approved Antennas
- Wall Mount AP822e Antenna Orientation
- A Regulatory Information
- Regulatory Specifications
- Declaration of Conformity, Federal Communication Commission
- Declaration of Conformity, Industry Canada
- Declaration of Conformity, R&TTE Directive 1999/5/EC
- VCCI Statement
- General Information of RF Exposure
- B Additional Notes
- Maximum EIRP
- Dual Concurrent Same Band Operation
- Manufacturing Information
- Distributed Antenna Systems (DAS)
- Air Handling Space Requirements
- Frequencies Blocked for Regulatory Compliance
- Restriction of Hazardous Substances
- C Cautions and Warnings
- Cautions
- Warnings
AP822eV2 Antennas 17
AP822eV2 Antennas
Radio-Antenna-Port Mappings
The following table lists which radio is associated with each antenna.
Attaching Antennas
An AP822eV2 has four external antenna ports, labeled A1, A3, A4 and A6, to be used for
attaching the antennas supplied with the AP. Do not leave any antenna connector open. All
connectors on the AP must be terminated either with antennas or with 50 ohm Reverse Polar-
ity SMA terminators. For a list of approved terminators, see http://www.merunetworks.com/
merusupport.
Antennas attached to a specific radio in AP822eV2 must all be of the same model. In case of
replacement, user must replace all the antennas.
TABLE 2: Radio-Antenna-Port Mappings
Antenna Port Radio / Channel
A1 Radio 1
A3 Radio 1
A4 Radio 2
A6 Radio 2