User's Manual
Table Of Contents
- Meru Networks AP822v2 Installation Guide
- 1 About AP822
- 2 Installing AP822eV2
- 3 Installing AP822iV2 and XP8i
- 4 Mounting AP822 and XP8i
- 5 Approved Antennas
- Wall Mount AP822e Antenna Orientation
- A Regulatory Information
- Regulatory Specifications
- Declaration of Conformity, Federal Communication Commission
- Declaration of Conformity, Industry Canada
- Declaration of Conformity, R&TTE Directive 1999/5/EC
- VCCI Statement
- General Information of RF Exposure
- B Additional Notes
- Maximum EIRP
- Dual Concurrent Same Band Operation
- Manufacturing Information
- Distributed Antenna Systems (DAS)
- Air Handling Space Requirements
- Frequencies Blocked for Regulatory Compliance
- Restriction of Hazardous Substances
- C Cautions and Warnings
- Cautions
- Warnings
AP Installation over Interlude & Silhouette T-Bars 33
4. Position the AP with the adapter plate installed, up to the T-Bar with the “MNT-SCRMKIT-
04” installed, at an angle. Be sure that the locating pin on the “MNT-SCRMKIT-04” is posi-
tioned in the indent on the adapter. Depress slightly to disengage T-Bar locks.
5. Twist the AP clockwise to engage T-Bar locks. There should be 2 audible clicks.
6. Verify that the AP comes online.