User's Manual
Table Of Contents
- Meru Networks AP822v2 Installation Guide
- 1 About AP822
- 2 Installing AP822eV2
- 3 Installing AP822iV2 and XP8i
- 4 Mounting AP822 and XP8i
- 5 Approved Antennas
- Wall Mount AP822e Antenna Orientation
- A Regulatory Information
- Regulatory Specifications
- Declaration of Conformity, Federal Communication Commission
- Declaration of Conformity, Industry Canada
- Declaration of Conformity, R&TTE Directive 1999/5/EC
- VCCI Statement
- General Information of RF Exposure
- B Additional Notes
- Maximum EIRP
- Dual Concurrent Same Band Operation
- Manufacturing Information
- Distributed Antenna Systems (DAS)
- Air Handling Space Requirements
- Frequencies Blocked for Regulatory Compliance
- Restriction of Hazardous Substances
- C Cautions and Warnings
- Cautions
- Warnings
AP Removal from Interlude & Silhouette T-Bar34
AP Removal from Interlude & Silhouette T-Bar
1. To remove the AP from ceiling, release the locking mechanism by pressing tab up, toward
the ceiling and slide the AP from right to left until it releases.
2. To remove the 15/16” T-Bar adapter/Wall mount adapter from the T-Bar, depress both T-
Bar locks at the same time and twist counter-clockwise to release.
Above a Standard Suspended Ceiling
By removing plastic facade, AP822eV2 can be installed in air-handling space. Use the
optional T-bar box hanger mounting kit to mount AP822eV2 above suspended ceiling T- rails.
The installation attaches the T-bar box hanger to the ceiling rails and then the AP822eV2
attaches to the T-bar box hanger.
AP822eV2 mounted above the ceiling has about 2-3 dBm less RF coverage than AP822eV2 mounted
under the ceiling.