Technical data

112 Meru System Director Configuration Guide © 2012 Meru Networks, Inc.
Dual-Ethernet Operation
Interface and Networking Commands
The following interface and networking configuration commands are available.
Table 4: Interface and Networking Commands
Command Purpose
controller(config)# interface FastEthernet
controller interface-index
Specify the controller interface index (0-31) and enter
FastEthernet interface configuration submode.
controller(config)# ip address ip-address
mask
Specifies the IP address and subnet mask for the
controller. This is used to specify the static IP address
if you are not enabling DHCP.
controller(config)# gw ip-address
Specifies the IP address of the default gateway. Used
to specify the gateway if you are not using DHCP.
controller# setup
Interactive script that helps set up hostname and
other system and networking parameters.
controller# show interfaces FastEthernet
statistics
Displays the summary table of Ethernet statistics for
the controller and APs.
controller# show interfaces FastEthernet
statistics controller
Displays the Ethernet statistics for the controller.
controller# show interfaces FastEthernet
statistics ap id
Displays the Ethernet statistics for the AP with the
given node ID.
controller# show second_interface_status
Displays the status of the second FastEthernet
interface when configured for redundant mode.