Technical data

248 Meru System Director Configuration Guide © 2012 Meru Networks, Inc.
Configuring Codec Rules
Id Class flow class : on
Destination IP : 10.11.31.0 (this is the subnet to be rate limited)
Destination IP match : on
Destination IP flow class : none
Destination Netmask : 255.255.255.0
Destination Port : 0
Destination Port match : none
Destination Port flow class : none
Source IP : 0.0.0.0
Source Netmask : 0.0.0.0
Source Port : 0
Source Port match : none
Source Port flow class : none
Network Protocol : 6
Network Protocol match : on
Network Protocol flow class : on
Firewall Filter ID :
Filter Id match : none
Filter Id Flow Class : none
Packet minimum length : 0
Packet Length match : none
Packet Length flow class : none
Packet maximum length : 0
QoS Protocol : other
Average Packet Rate : 0
Action : forward
Drop Policy : head
Token Bucket Rate : 46875
Priority : 0
Traffic Control : on
DiffServ Codepoint : disabled
Qos Rule Logging : on
Qos Rule Logging Frequency : 60
3. Configure Chariot to send a TCP downstream to the different clients in
10.11.31.xxx using the throughput script.
All the clients in 10.11.31.xxx network should now share the 3 Mbps from each indi-
vidual source.
Configuring Codec Rules
Codec rules are configurable and can be specified with the commands in this section.
Note: If your SIP phones support "ptime" then you will not need to configure
any codec rules. Otherwise, you should configure QoS rules and ensure the rule
you set is based on the packetization/sample rate that the phone uses.