Technical data

How Does the GUI Relate to CLI Commands?

Throughput bottlenecks sh statistics top10 -ap -problem

(shows loss %)

analyze-capture start, analyze-cap-

ture stop, analyze-capture capture

System Dashboard (Monitor > Dashboard

> System)

High-volume users sh statistics top10-station-talker Stations Dashboard (click Monitor > Dash-

board > Station)

Why a user’s connection failed station-log/station add

analyze-capture

Station Diagnostics (click Monitor > Diag-

nostics > Station)

Dead spots sh topoap Station Diagnostics (Monitor > Diagnostics

> Station > Signal Strength Chart)

Station retries sh station Monitor > Dashboard > Station > Retries

chart

User’s location sh station or sh topostation NA

Overloaded radios sh station

sh statistics top10-ap-problem

Monitor > Dashboard > Radio > Retries

chart

Radio Dashboard (Monitor > Dashboard >

Radio > Throughput Chart)

High-loss radios sh station

analyze-capture start, analyze-cap-

ture stop, analyze-capture snapshot

Monitor > Dashboard > Radio > Loss %

chart

Controller Dashboard (Monitor > Control-

ler > High-Loss Radio chart)

Noisy radios NA Monitor > Diagnostics > Radio

Controller Dashboard (Monitor > Control-

ler > Noise Level chart)

Radio Management Overhead sh interfaces Dot11Radio statistics Monitor > Dashboard > Radio > Manage-

ment Overhead Distribution chart

Average Station data rates show station 802.11 | “802.11a”

show station 802.11 | “802.11b”

show station 802.11 | “802.11g”

show station 802.11 | “802.11ab”

show station 802.11 | “802.11bg”

show station 802.11 | “802.11bgn”

Monitor > Dashboard > Station > Average

Rate charts

I need to know... With the CLI With the GUI