User's Manual
Table Of Contents
- Contents
- Introduction
- OAP180 Access Point Features
- Special Release Software for Meru Controllers
- OAP180 Hardware Installation Instructions
- Limitations and Advisories
- Regulatory Information
- Documentation for this Release
- Contacting Meru
OAP180 Hardware Installation Instructions 11 of 24
© 2007 Meru Networks, Inc.
4. Connect the OAP180 bracket and the pole bracket. See Figure 4.
Figure 4: Connecting the Two Brackets
Mounting OAP180 with the Wall-Mounting Bracket
Attach the bracket to a wall with the flat side flush against the wall (see Figure 5).
Perform the following steps to mount the unit to a wall using the wall-mounting
bracket:
1. Position the bracket in the intended location and mark the position of the four
mounting screw holes.
2. Drill holes in the wall that match the screws and wall plugs included in the bracket
kit, and then secure the bracket to the wall.
Figure 5: Attaching Bracket to Wall
3.
Use the included nuts to tightly secure the OAP180 to the bracket.