User's Manual
Table Of Contents
- Contents
- Introduction
- OAP180 Access Point Features
- Special Release Software for Meru Controllers
- OAP180 Hardware Installation Instructions
- Limitations and Advisories
- Regulatory Information
- Documentation for this Release
- Contacting Meru
OAP180 Hardware Installation Instructions 13 of 24
© 2007 Meru Networks, Inc.
Connect External Antennas and Ground Wire to OAP180
When deploying an OAP180, first mount external antennas and then connect them to
the OAP180. Follow these steps:
1. Mount the external antenna on the same supporting structure as you did the
OAP180, within 3 m (10 ft) of it, using the bracket supplied in the antenna
package.
2. Connect the antenna to the OAP180’s N-type connector using the RF coaxial cable
provided in the antenna package.
Figure 7: Connect the Antenna Cables
3.
Apply weatherproofing tape to the antenna connectors to help prevent water
entering the connectors.