User's Manual

OAP180 Hardware Installation Instructions 17 of 24
© 2007 Meru Networks, Inc.
Configure the OAP180 Access Point
Once the OAP180 is plugged in, the Meru controller will detect and connect the
OAP180. The OAP180 can then be further configured through either the Controller
GUI or CLI.
Configure OAP180 Radio Operation with the Web UI
Configure OAP180 Radio Antennas with the CLI
Configure OAP180 Radio Operation with the CLI
Configure OAP180 Radio Operation with the Web UI
To use the Web UI to set up the OAP180, follow these steps from the controller:
1. Click Configuration and then Radio from the Devices list. A table of Wireless AP
Interface Details displays.
2. Select the checkbox of the second wireless interface of the OAP180 that requires
modification, and then click Settings. The Wireless Interface Configuration Update
page displays.
3. From the Channel drop-down list, select the channel the interface will use
(channels have been filtered to only reflect appropriate selections).
4. From the RF Band Selection drop-down list, select 802.11a
5. Click OK to save your change and return to the Wireless Interface Configuration
page.
6. Select the checkbox for the first wireless interface of the OAP, and click Settings.
The Wireless Interface Configuration displays.
7. From the Channel drop-down list, select the channel the interface will use
(channels have been filtered to only reflect appropriate selections).
8. From the RF Band Selection drop-down list, select 802.11b, 802.11g, or
802.11bg. Default mode is 802.11bg.
9. Click OK to save your change and return to the Wireless Interface Configuration
page.
10. Continue setting any other OAPs as needed, by repeating the above steps.
11. Save this configuration by clicking on Save.