User's Manual

6 Installing OAP433e
This chapter describes how to physically install an OAP433e, which is supported
on System Director Versions 6.0 SR2 and later. It contains the following sections:
• Unpacking the OAP433e
• Installation Requirements
• Assembling the Waterproof Ethernet Connector
• Installing the Access Point
• Where to Go From Here
• Unpacking the OAP433e
Note
Please use the OAP433 series only with Listed ITE or equivalently-rated
equipment.
6.1 Unpacking the OAP433e
Confirm that the OAP433e shipping boxes contain the following items (see Figure
27, OAP433e outdoor access point (top & bottom)
• OAP433e Outdoor Access Point
• Water barrier for the Ethernet connection (when shipped, this is not
connected to the AP)
• Wall/Pole Mount Hardware Kit for mounting OAP433e to a 2” to 3”
diameter steel pole or tube or as part of a radio or tower structure (3
pieces)
• Screws and bolts for assembling the mounting bracket
• Drywall screws (for wall-mounted installation)
• Ground wire
Figure 27, OAP433e outdoor access point (top & bottom)
6.2 Installation Requirements
In addition to the hardware supplied by Meru Networks, you need the following
required accessories.
• Antennas (sold separately)