User's Manual

attached to another circular portion (seeFigure 32, Square mounting
bracket), attach the OAP433e to the square portion of the mounting
bracket by placing the bracket flat against the bottom of the AP and
inserting screws into the corners of the bracket portion. The holes on the
bracket should correspond to the holes on the bottom of the AP. Figure
33, Square mounting bracket attaches to bottom of OAP433e
Figure 32, Square mounting bracket
Figure 33, Square mounting bracket attaches to bottom of OAP433e
Note
Note that the circular portion of the bracket should be facing to the side of the AP
(the AP’s sides are the faces that do not have antennas or other attachments).
This is to ensure that the AP is properly oriented when the bracket is fully
assembled.
• Insert the circular portion of the bracket attached to the AP into the hollow
cone portion of the bracket on the wall. The two should fit somewhat
snugly, although a screw assembly will be required to hold them in place.
• Run one of the long screws provided in the package down through the
hole that runs through both portions of the bracket. The head of the
screw should fit into the hexagonal slot on the top of the bracket
assembly.
• On the other end of the screw (i.e., the one that doesn’t have the
hexagonal head), slide a flat washer and then a lock washer into place.