User's Manual

Installing the Access Point 9
Figure 2: OAP832e Grounding Holes
Test Basic Link Operation
Prior to deploying the AP, it is recommended that users connect it to an existing Meru deploy-
ment in order to ensure basic functionality. This can be done indoors in a controlled setting,
prior to going through the trouble of mounting it externally. To do so, simply connect the AP to
an existing controller and verify that the controller recognizes it. If so, proceed with the follow-
ing section in order to deploy the AP.
Mounting the Access Point
The OAP832e can be mounted on the following (brackets are included):
• 1.3” to 16” diameter round pole or 1.3” to 16” wide square pole
• Wall
This chapter provides all the information that users need to install Meru OAP832e. After user
completing installation procedure, see the Meru System Director Configuration guide for
detailed instructions on the various configuration options.
Follow all safety precautions mentioned in the “Safety Precautions” on page 2 section.