User's Manual

Mounting OAP832e on a Pole 13
3.
Determine which mounting, vertical or horizontal to
be assembled. Drive the four round head screws to
attach the Pole Mount Bracket to the mounting base.
4. The following figure illustrates the rear section of
the bracket that has the tab for pole clamp and
slots for pole strap.
5. For round pole larger than 5.91 inch (150mm) in diameter,
thread the open end of the pole strap through the two side
slots and the tab on the bottom of bracket and for square
pole wider than 6.06 inch (154mm), thread the pole strap
through the two side slots only and not through the tab on
the bottom of the bracket. For smaller poles, thread the
open end of the pole strap through the tab on the bottom
of bracket.