User's Manual
Table Of Contents
- Meru Networks OAP832e Installation Guide
- Table of Contents
- About OAP832e
- Installing OAP832e
- Approved Antennas
- Regulatory Information
- Additional Notes
- Cautions and Warnings
Mounting OAP832e on a Wall 15
Mounting OAP832e on a Wall
1. Determine where the AP is to be placed and mark
location on the surface for the four mounting holes.
You may adjust the position with a level. Use the
appropriate drill bit to drill four 8mm diagram and
37mm depth holes in the markings and hammer the
bolts into the openings.
2. Place the lock and fat washer on the round head screws and
drive the screws to attach mounting base to the back of the
Access Point.
3. Attach the device onto the wall by tightening the
bolts fat washers and nuts to secure the mounting
base to the mounting surface.