User's Manual

Check OAP832e LED Activity16
Check OAP832e LED Activity
When OAP832e first connects to the controller (and any time the access point is rebooted),
the AP initializes and is then programmed by the controller. When the AP first powers up, all
LEDs are green as in Figure 3 on page 16.
Figure 3: OAP832e Status LEDs
After the OAP832e is connected, check the status of the LEDs. The functions of the LEDs are
described below.
TABLE 2: LED Descriptions
LED COLOR DESCRIPTION TROUBLESHOOTING
POWER RED /
GREEN
TBD
LAN 1 GREEN ON - Link Up
OFF - Link Down
If the status LED is blinking red and
yellow, there is an alarm on the AP.
Determine what the alarm is by clicking
Monitor > Dashboard > Alarms and
looking at the AP alarms.
You can also use the CLI commands
show alarm and show log.
LAN 2 GREEN ON - Link Up
OFF - Link Down
2.4 GHz GREEN ON - Link Up
OFF - Link Down
5 GHz GREEN ON - Link Up
OFF - Link Down