User's Manual
Table Of Contents
- Meru Networks OAP832e Installation Guide
- Table of Contents
- About OAP832e
- Installing OAP832e
- Approved Antennas
- Regulatory Information
- Additional Notes
- Cautions and Warnings
Where to Go From Here 17
Change LED Appearance
If you want to change the appearance of the LEDS, follow these steps:
1. From the controller, click Configuration > Devices > AP, and then select the AP.
2. Select one of these settings for the LED Mode setting:
• Normal: LEDs are as described above
• Blink: Sets all LEDs flashing; this is useful to locate an AP
• Dark: Turns off all LEDs
3. Click OK.
Where to Go From Here
Now that the OAP832e is installed, refer to the Meru System Director Getting Started Guide
for instructions on initializing the hardware. Return to this chapter to check the status of the
LEDs once the WLAN is operational.