User's Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- About This Guide
- About the Radio Switch RS4000
- Installing the RS4000
- Configuring the Meru RS4000
- Managing and Monitoring the RS4000
- Command Reference
- MIB Definition Reference
- RFC 1212 MIB-System Group
- RFC 1213 MIB-Interface Group
- IEEE 802.11 MIB-Dot11 Counter Table (Statistics)
- Meru Enterprise MIB-AP System Entry
- Meru Enterprise MIB-Network Configuration MIB
- Meru Enterprise MIB-Load Balancing MIB
- Meru Enterprise MIB-Global Radius Profile Configuration MIB
- Meru Enterprise MIB-Meru Interface Table
- Meru Enterprise MIB-Trap Community Interface
- Meru Enterprise MIB-SNMP Community Interface
- Meru Enterprise MIB-SNMP Traps Flag
- Meru Enterprise MIB-Global Entry
- Meru Enterprise MIB-Syslog Table
- Meru Enterprise MIB-File Transfer Table
- Meru Enterprise MIB-Upgrade Flag
- Meru Enterprise MIB-Upgrade Status Flag
- Specifications
- Regulatory Information
- Channels
- Translated Safety Warnings
88 Meru Radio Switch RS4000 Reference Guide
show unsavedconfig
Show unsaved configuration changes.
Syntax show unsavedconfig
Usage This command lists the commands that have been executed since the last saved version of the
configuration. For the commands listed in this command’s output to take effect, the user must
use the command save-conf. If there have been no commands executed since the last saved
configuration, the output “No Un-saved Configuration!!” is displayed.
Examples meru_ap# show unsavedconfig
NOTE: Running configuration is
displayed inside brackets"()"
[snmp_agent]
sysContact = merunetworks (meru_ap)
Related
Commands
save-conf