User's Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- About This Guide
- About the Radio Switch RS4000
- Installing the RS4000
- Configuring the Meru RS4000
- Managing and Monitoring the RS4000
- Command Reference
- MIB Definition Reference
- RFC 1212 MIB-System Group
- RFC 1213 MIB-Interface Group
- IEEE 802.11 MIB-Dot11 Counter Table (Statistics)
- Meru Enterprise MIB-AP System Entry
- Meru Enterprise MIB-Network Configuration MIB
- Meru Enterprise MIB-Load Balancing MIB
- Meru Enterprise MIB-Global Radius Profile Configuration MIB
- Meru Enterprise MIB-Meru Interface Table
- Meru Enterprise MIB-Trap Community Interface
- Meru Enterprise MIB-SNMP Community Interface
- Meru Enterprise MIB-SNMP Traps Flag
- Meru Enterprise MIB-Global Entry
- Meru Enterprise MIB-Syslog Table
- Meru Enterprise MIB-File Transfer Table
- Meru Enterprise MIB-Upgrade Flag
- Meru Enterprise MIB-Upgrade Status Flag
- Specifications
- Regulatory Information
- Channels
- Translated Safety Warnings
Performing the Installation
Installing the RS4000 15
Figure 4: RS4000 Top Panel
4. Attach two Ethernet cables to the Ethernet ports labeled
ETH 1 and ETH 2 on the top panel of the
RS4000.
5. Place the RS4000 into the Hoffman enclosure, and align the plate screwholes with the holes in the
Hoffman enclosure.
6. Pass the Ethernet and antenna cables out of the Hoffman enclosure through the cable pass-through
holes, if necessary.
7. Tighten the captive screws on the mounting plate to the Hoffman enclosure.
8. Attach the antenna cables to the antenna.
9. Position and align the bottom of the antenna over the threaded stud on the antenna mount arm and
tighten the threaded stud to the antenna.
10. Test the reception for the antenna and then securely tighten the antenna.
11. Close the lid to the Hoffman enclosure and secure the lock.
12. Connect the two Ethernet cables to the PoE device.
Power On Components
Apply power to the PoE component and network switch to power up the RS4000. Continue with the
software configuration in the next chapter.
ETH 1ETH 1
5V DC
ETH 2ETH 2
ANT 2ANT 2ANT 1ANT 1
ETH 1 and ETH 2
ANT 1 and ANT 2