User's Manual

Command Reference 57
set system
Sets system level configuration settings.
Syntax set system Contact name
set system Name RS4000_name
set system Location description
set system hostname hostname
set system syslog_server IP_address
Usage The set system command configure basic system parameters for identifying the RS4000 and
providing its Regulatory Domain setup. Identification text provides labels for a Contact,
Location description, Name of unit, and Hostname assigned to the Radio Switch. It also allows
you to designate the IP address for the system that is to be used as the syslog server.
Examples To configure the hostname of the Radio Switch to library_RS, use the command:
# set system hostname library_RS
To designate the IP address (192.168.220.1 for example) of the system that is to be used as the
syslog server, use the command:
# set system syslog_server 192.168.220.1
Contact name Specifies an identifying name to be used as the contact
reference.
Name RS4000_name Specifies an identifying name for the RS4000.
Location description Specifies descriptive text for where the RS4000 is
located.
hostname hostname Specifies the hostname for the Meru Radio Switch. A
maximum of 32 characters can be used. By default, the
host name is set to meru_ap.
syslog_server IP_address IP address of the system to be used as the syslog server.
The syslog server is the location where the system log
file resides. See “Checking Syslog Messages” on
page 29 for a complete list of messages.
Note:
A complete list of the syslog messages can be found in “Checking Syslog
Messages” on page 29.