User's Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- About This Guide
- About the Radio Switch RS4000
- Installing the RS4000
- Configuring the Meru RS4000
- Managing and Monitoring the RS4000
- Command Reference
- MIB Definition Reference
- RFC 1212 MIB-System Group
- RFC 1213 MIB-Interface Group
- IEEE 802.11 MIB-Dot11 Counter Table (Statistics)
- Meru Enterprise MIB-AP System Entry
- Meru Enterprise MIB-Network Configuration MIB
- Meru Enterprise MIB-Load Balancing MIB
- Meru Enterprise MIB-Global Radius Profile Configuration MIB
- Meru Enterprise MIB-Meru Interface Table
- Meru Enterprise MIB-Trap Community Interface
- Meru Enterprise MIB-SNMP Community Interface
- Meru Enterprise MIB-SNMP Traps Flag
- Meru Enterprise MIB-Global Entry
- Meru Enterprise MIB-Syslog Table
- Meru Enterprise MIB-File Transfer Table
- Meru Enterprise MIB-Upgrade Flag
- Meru Enterprise MIB-Upgrade Status Flag
- Specifications
- Regulatory Information
- Channels
- Translated Safety Warnings
Command Reference 71
show factoryconfig
Displays the factory-set configuration.
Syntax show factoryconfig
Usage Shows factory-set configuration settings. This command shows the initial settings of all
configuration parameters, and may be helpful to refer to if some user-initiated configuration
changes are not working and you would like to selectively revert to the default settings.
Examples The following shows an except of the factory-set configuration file output:
meru_ap# show factoryconfig
[system_config]
host_name=meru_ap
syslog_server=
[network_config]
boot_proto = static
ip_addr = 192.168.1.1
mask = 255.255.255.0
def_gateway=
domain=
dns1=
dns2=
dns3=
dns4=
[radio1-1]
Related
Commands
show runningconfig