User's Manual

Command Reference 73
show interfaces
Displays the current network interface settings.
Syntax show interfaces if
Usage Use this command to see the Ethernet (eth1 and eth2) and RF interfaces (radio1-1, radio2-
1, radio1-2, and radio2-2) for the RS4000. Alternately, an interface can be specified by a
number (for example, 3 for radio1-1)
if Optional. Specifies the interface to show (eth1| eth2 | radio1-1 |
radio2-1| radio1-2 | radio2-2) or 1, 2, 3, 4, 5, 6, respectively).
Table 5: Field Descriptions for show interfaces
Parameter Description
[Interface Name] The name of the interface, for example, eth1, radio1-1.
Index The index for identifying this interface.
Description Shows a description of the interface.
Type Type descriptor.
Mtu The Maximum Transmission Unit (MTU) for the interface.
Speed (Mbits/sec) The configured speed for the interface.
PhysAddress The MAC address of the interface.
AdminStatus Indicates whether the wireless interface has been enabled
(Up) or taken out of service (Down).
OperStatus Indicates whether the interface is operational (up) or
unavailable (down)
Last Change The date the interface was changed last.
InOctets The number of octets received by this interface.
InUCastPkts The number of unicast packets received by this interface.
InNUCastPkts The number of non-unicast packets received by this interface.