Use and Care Manual

SAFE OPERATION & PROGRAMMING
1
st
USER CODE is factory set to :
1-5-9
2
nd
USER CODE is factory set to :
1-6-8
EMERGENCY CODE is factory set to :
1-2-3-4-5-6-7-8
IMPORTANT : Because the codes are factory set, we highly recommened
changing the codes to your own unique codes immediately!
HOW TO OPEN YOUR SAFE
1
Input : Code - # [light stays green for 5 seconds]
2
Turn the handle to the unlocked position before the green light disappears
Example : 1-5-9-#
Invalid Code: 5 ‘Beeps’
OPENING YOUR SAFE WITH THE EMERGENCY CODE
1
Input : Emergency Code - #
2
Wait 30 seconds, the green light will appear & stay on for 5 seconds
[Do NOT make any entries during the 30 second wait period]
3
Turn the handle to the unlocked position before the green light disappears
Wrong Try Penalty
If 3 wrong codes are entered consecutively, the keypad will shut down for
a period of 15 minutes. During this shut down period, the keypad will not
accept any codes.
CHANGING THE 1
ST
USER CODE
[Code length: 1-8 digit code]
NOTE : Test the new codes several times before closing the door.
1
Located the red button on the inside hinge side edge of the door
2
Press the red button [Lock will ‘Beep’ 2 times with the yellow light on]
2
Input : Your New Code -
*
[lock will ‘Beep’ 2 times]
Unsuccessful Code Change : 5 ‘Beeps’ [the old code is still valid; repeat
steps 1 - 3]
CHANGING THE 2
ND
USER CODE
[Code length: 1-8 digit code]
NOTE : Test the new codes several times before closing the door.
1
Located the red button on the inside hinge side edge of the door
2
Input : 0 - 0 on the keypad & press the red button
[Lock will ‘Beep’ 2 times with the yellow light on]
2
Input : Your New Code -
*
[lock will ‘Beep’ 2 times]
Unsuccessful Code Change : 5 ‘Beeps’ [the old code is still valid; repeat
steps 1 - 3]
MSL-50 ELECTRONIC LOCK INSTRUCTIONS
|
PG.3