Use and Care Manual
CHANGING THE EMERGENCY CODE
[Code length: 8 digit code]
NOTE : Test the new codes several times before closing the door.
1
Located the red button on the inside hinge side edge of the door
2
Input : 0 - 1 - 0 on the keypad & press the red button
[Lock will ‘Beep’ 2 times with the yellow light on]
2
Input : Your New Code -
*
[lock will ‘Beep’ 2 times]
Unsuccessful Code Change : 5 ‘Beeps’ [the old code is still valid; repeat
steps 1 - 3]
LOW BATTERY WARNING
Red light appears when you open the safe along with the green light
Enter your code & get a valid response but the lock does not respond
CHANGING YOUR BATTERIES
1
Locate the battery cover on the bottom edge of the keypad & remove the
cover by pulling on the tab
2
Carefully & gently remove the 9-V battery from the compar tment
C AUTION : Hold onto battery connector to avoid pulling wires out of
housing.
3
Carefully re-insert the new 9V batter y, do not force the battery into the
compartment
4
The lock will retain all current codes & settings
9V
1
2
3
4
5
6
7
8
9
#
*
0
ĂƩĞƌLJ
ŽŵƉĂƌƚŵĞŶƚ
ĂƩĞƌLJ
ŽŶŶĞĐƚŽƌ
ϵsĂƩĞƌLJ
PG.4
|
MSL-50
ELECTRONIC LOCK INSTRUCTIONS