Use and Care Manual

ACTIVATE USER CODES [Code length : 3 - 8 digit code]
1
Input :
*
-
*
[lock will ‘Beep’ 2 times]
2
Input : 3-3-3-# [lock will ‘Beep’ 2 times]
3
Input : Current Master Code-# [lock will ‘Beep’ 2 times]
4
Input : [User#] - # [User#: Specify which user you would like to activate: 1,
2, 3, or 4]
5
Input : New User Code - # [lock will ‘Beep’ 2 times]
6
Re-Input : New User Code - # [light stays green for 3 seconds]
Example :
*
-
*
-3-3-3-# - Master Code - #-4-# - New User Code - # - New User Code - #
Unsuccessful Code Activation : 5 ‘Beeps’ [repeat steps 1 - 6]
CHANGE USER CODES [Code length : 3 - 8 digit code]
1
Input :
*
-
*
[lock will ‘Beep’ 2 times]
2
Input : 4-4-4-# [lock will ‘Beep’ 2 times]
3
Input : Current User Code-# [lock will ‘Beep’ 2 times]
4
Input : [User#] - # [User#: Enter the User # that identifies the Current User
Code on Step 3]
5
Input : New User Code - # [lock will ‘Beep’ 2 times]
6
Re-Input : New User Code - # [light stays green for 3 seconds]
Example :
*
-
*
-4-4-4-# - User 2 Code - #-2-# - New User Code - # - New User Code - #
Unsuccessful Code Activation : 5 ‘Beeps’ [repeat steps 1 - 6]
DELETE USER CODES [Code length : 3 - 8 digit code]
1
Input :
*
-
*
[lock will ‘Beep’ 2 times]
2
Input : 6-6-6-# [lock will ‘Beep’ 2 times]
3
Input : Current Master Code-# [lock will ‘Beep’ 2 times]
4
Input : [User#] - # [lock will ‘Beep’ 2 times]
[User#: Specify which user you would like to delete: 1, 2, 3, or 4]
5
Re-Input : [User#] - # [light stays green for 3 seconds]
Example :
*
-
*
-6-6-6-#-Master Code-#-1-#-1-#-New User Code- #-New User Code-#
[ This will delete User 1]
Unsuccessful Code Change : 5 ‘Beeps’ [repeat steps 1 - 5]
PG.5
|
MSL-500 ELECTRONIC LOCK INSTRUCTIONS