Use and Care Manual

5
Input the User Number you would like to set or change:
2 = User 2; 3 = User 3; 4 = User 4; 5 = User 5
[[ NEW_PW: ]] will appear on the display
6
Input a new code for that User [1-8 Digits long]
7
Input:
#
; [[ SUCCESS!]] will appear on the display if entered correctly
Example :
*
-
#
- 4560 -
#
- 1 - 2 - 1234 -
#
- 1234 -
#
If at any Step you get a [[ FAILURE ]] or any errors, you must begin from
Step 1 again
DELETING USER CODES
NOTE : You must know the Master Code to delete User Codes.
1
Input:
*
2
Input:
#
; [[ MASTER_PW ]] will appear on the display
3
Input : Master Code -
#
; [[ 0_EXIT ]] will appear on the display
4
Input : 2; [[ D-NO: ]] will appear on the display
5
Input the User Number you would like to delete:
2 = User 2; 3 = User 3; 4 = User 4; 5 = User 5
[[ 1=YES OR 0=NO ]] will appear on the display
6
Input: 1; [[ SUCCESS!]] will appear on the display
Example :
*
-
#
- 4560 -
#
- 2 - 2 - 1
If you change your mind & decide not to delete the selected User Code,
press 0 instead of 1 & the procedure will cancel (as it appears on display: [[
...0=NO ]])
CHANGING THE DISPLAY MODE
NOTE : You must know the Master Code to change the Display Mode.
1
Input:
*
2
Input:
#
; [[ MASTER_PW ]] will appear on the display
3
Input : Master Code -
#
; [[ 0_EXIT ]] will appear on the display
4
Input : 7; [[ DISPLAY MODE ]] will appear on the display
If the Display Mode is changed successfully, all codes
will now appear as asteriks [
*
] instead of digits
To change the Display Mode back, repeat Steps 1-4
Example :
*
-
#
- 4560 -
#
- 7
VIEWING THE LOG
NOTE : You must know the Master Code to view the Log.
1
Input:
*
2
Input:
#
; [[ MASTER_PW ]] will appear on the display
PG.4
|
MFS-SERIES ELECTRONIC LOCK INSTRUCTIONS