Use and Care Manual

OPENING YOUR SAFE [For the first time]
1
Input :
*
[Star t Button; refer to graph]
2
Input the given Factory Code
3
Input :
#
[End Button; refer to graph]
Example :
*
- 4 - 5 - 6 - 0 -
#
4
If entered correctly, [[ MATCH! ]] will appear on the display. You will hear a
slight ‘Click’, and have approximately 3 seconds to open the door
5
Pull the handle downward to open the door
If a wrong code is entered, the lock will ‘Beep’ 2 times & [[ ERROR ]] will
appear on the display
If a wrong code is entered 3 times consecutively, the lock will go into
Lock-Out Mode for 3 minutes, [[ WAIT ]] will appear on the display & ‘Beep’
every couple seconds for the duration of the Lock-Out period
NOTE : During Lock-Out Mode you will not be able to insert any codes. If
you attempt to remove the batteries & reinsert them, the Lock-Out Mode
time will reset.
CHANGING THE MASTER CODE
IMPORTANT : Because the codes are factory set, we highly recommened
changing the codes to your own unique codes immediately!
NOTE : Always perform this operation with the door open! Test the new
code several times before closing the door.
1
Press the Reset button located inside the door panel [Reset Button; refer to
graph]
2
[[ NEW_PW ]] will appear on the display along with a ‘Beep’
3
Input your new Personal Code. You will have approximately 10 seconds to
enter your new code [1-8 Digits long]
4
Input:
#
; [[ NEW_PW ]] will appear on the display and ‘Beep’ 3 times
IMPORTANT : Try your new code at least 3 times with the door open
before closing the safe shut.
ADDING & CHANGING ADDITIONAL USER CODES
NOTE : You must know the Master Code to set additional User Codes.
1
Input:
*
2
Input:
#
; [[ MASTER_PW ]] will appear on the display
3
Input : Master Code -
#
; [[ 0_EXIT ]] will appear on the display
4
Input : 1; [[ C-NO: ]] will appear on the display
MFS-SERIES ELECTRONIC LOCK INSTRUCTIONS
|
PG.3