Full Product Manual

1. Fix shower head and pillow first.
2. Connect the drain hose to the cloaca.
3. Connect to the cool and hot water pipe.
4. Adjust the screw on the feet to make the bathtub horizontal.
5. Connect to power supply, then fill water to have a test.
Voltage: 220-240V 50/60Hz Power: 1HP
Size: 1700x800x780mm
Turn the cool/hot switch to adjust the water temperature, turn
the shift switch to fill water through shower head or faucet or
waterfall nozzle. Stop to fill water when the water level is 10-
20mm above the spray nozzle.
Press the pump switch to start the pump and Jacuzzi, and turn
the air regulator to adjust the hydraulic power. Push the nozzle
to change the water spray direction. Press the switch again to
turn off the pump.
Turn the cool/hot water switch to get suitable temperature, then
turn the shift switch to use shower head to take a shower.
Press the pump switch to turn off the pump, then turn the drain
switch to let out the water,when stop use ,turn off the power
source switch and the water supply switch.
1. The rated power of this product is 220V 50Hz, please make
sure not to overload it.
2. Make sure to fix leakage protection device, and the socket
must be connected with earth line.
3. Please don't block the water recycle nozzle by any part of
your body, if that occurs, turn off the pump or power at once
4. A switch for the supply of the hot /cool water must be
installed,when stop to use this product the water supply
switch and the power source switch should be turned off.
5. Check the water level if it is 10-20mm above the spray
nozzle before you start the pump or the pump could be
damaged.
6. Don't use corrosive detergent to clean the bathtub, you
could use common daily detergent or toothpaste to clean it.
7. Dispose of the product according to the local law when it is
out of use.
8. Please contact the local dealer for help if you have any
problem.
1700
800
1700
780
300
400