Installation Instructions

FCC Statement

The CDM-300 modular transmitter is only allowed to be installed into other devices under license and

instruction of Mesh Systems.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference and

(2) This device must accept any interference received, including interference that may cause undesired

operation.

INSTRUCTION TO THE USER

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

* Reorient or relocate the receiving antenna.

* Increase the separation between the equipment and receiver.

* Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

* Consult the dealer or an experienced radio/TV technician for help.

In order to maintain compliance with FCC regulations, shielded cables must be used with this

equipment. Operation with non-approved equipment or unshielded cables is likely to result in

interference to radio and TV reception. The user is cautioned that changes and modifications made to

the equipment without the approval of manufacturer could void the user's authority to operate this

equipment.

To satisfy RF exposure requirements, this device and its antenna must operate with a separation

distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with

any other antenna or transmitter.

PAGE 1
FCC Statement The CDM-300 modular transmitter is only allowed to be installed into other devices under license and instruction of Mesh Systems. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference received, including interference that may cause undesired operation.
PAGE 2
Labeling Requirements A label must be affixed to the device into which the module is installed. The label should read: Contains Transmitter Module FCC ID: 2AC46-CDM300 -orContains FCC ID: 2AC46-CDM300 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.