Instruction Manual
Base Station Installation
1
netLiNKControls.com - 214.net.LiNK - Made in USA
If there is only one BS and one Wall Mount Node in a system, a smaller 900MHz antenna will be
installed on the BS and the 25’ cable and roof mounted antenna won’t be supplied or required to be
installed as noted above.
The cellular (GSM) antenna is already secured on the top right side of the BS and does not need to be
altered.
Install the lightning arrestor
doing so will result in permanent damage to the BS and will void the warranty.
Aach the coax cable from the lightning arrestor up the wall to the BFA antenna which is mounted
Verify
Change the lock combinaon
netLiNK Tech Support.
Install the ID decal
Take photographs
1
Mount the Base Staon (BS) on a wall
Run the power circuit
enclosure and ensure that the BS has an uninterrupted power supply.
2
3
4
5
6
7
8
9
“acvate the Base
Staon” and “commission” the system - please reference the project name and address.
Mount the 900MHz BFA antenna to the
supplied mounng hardware bracket and
installer. Cut the conduit length so that the
least 4 feet of clearance. Now route and
sharp 90
O
angles or sharp bends.