User manual

To upgrade the firmware:

1. Click

the Browse button to locate the firmware file.

2. Click the “Load Firmware to Camera” button to start upgrade.

3. When prompted, click OK to proceed.

4. Wait about 20~60 seconds until the file is successfully updated.

Once update is completed, the

browser will show a message reads “Firmware update success”. Then it will take 60 seconds to restart

the camera.

5. The utility will automatically go back to live view screen after firmware has been updated successfully.

You can also perfume these tasks on the Firmware page:

 Restart camera: Restart your camera. This will cause all streams to disconnect.

 Factory Default: Reset all of the camera settings to the defaults, except network settings. After

you confirm to reset, the camera will reset and restart automatically. When complete, you will

return to the live view page.

 Hardware Factory Default: Reset all of the camera parameters to the defaults, including the

network settings.