Instruction manual

Setting

2.4 Camera/Event Settings

External alarms and motion sensors can be set. Connecting a sensor or other device

to the alarm input terminal notifies an alarm when the sensor detects a trouble.

For example, mounting a sensor on a door notifies an alarm each time the door is

opened or closed. By setting the motion sensor to activate, an alarm is notified by

detecting a change in a screen.

1 Click "Image Settings" on the setting menu.

･ A sub menu for Camera Settings will appear.

2 Click "Event" in the sub menu.

･ The screen of "Camera - Alarm Settings" will appear.

Configure each setting items.

･ Click the Save button to save settings.

･ The settings will not be reflected unless the Save button is clicked.

● Alarm In

1) Set an "alarm" to be detected.

ON: Detects an external alarm.

OFF: Does not perform "Alarm In".

2) Set "Input type" for alarms if "Function" is set to other than "OFF".

Normally Opened (NO): A no-voltage contact system. Set in case of normally

open, closed in case of an alarm.

Normally Closed (NC): A no-voltage contact system. Set in case of normally

closed, open in case of an alarm.

NOTE

● Camera starts alarm recording when camera detects alarm signal. (Signal length

requires more than 100ms).

● Motion Detection

1) Function

ON: Camera detects motion. (A change in the screen is detected and an alarm

is sent)

OFF: Camera does not detect motion.

2) Sensitivity

Set "Sensitivity."

HIGH: It works with even a small change in brightness or motion is detected.

MIDDLE: Intermediate between HIGH and LOW.