Owner's Manual

8
CD Operation
The unit is designed to play normal music CD disc bearing the correct
identification logo. If the disc does not confirm tothe standard, it may not be
played back properly.
Caution:
Playback of CD-R / CD-RW may depend on recording conditions.
Do not attach a seal or label to either side (the recordable side or the labeled side) of a CD-
R/ RW disc. It may cause malfunction.
Do not load a blank CD-R/ RW disc. It will take over 1 minute to read the disc. The disc may
be damaged if you try to open the CD Door while reading the disc. CD-ROM, CD-I, CDV,
VCD, DVD or computer CDs are not possible to be read.
Loading disc
1. Press and toggle the FUNCTION button to switch to CD mode.
2. Press down the OPEN/CLOSE AREA on the CD door on the top of the unit to unlock and
open the CD door.
3. Hold the CD disc by its edge with CD graphical side facing up and put it onto the CD
compartment after the CD door is opened. Make sure that the disc label is facing up.
4. Close the CD door and make sure the VOLUME knob is not in minimum position.
CD playback
After loading the disc, the disc will begin spinning and the total number of the tracks on the disc
will be shown on the display, and the first track/file on the CD will be played back automatically.
Play/Pause Control
To pause playback temporarily by pressing the PLAY/PAUSE button. Music playback will be
paused and the current elapsed track number will be shown on the display and the play icon will
be blinking. Press the PLAY/PAUSE button again to resume playback.
Stop playback
To stop playback, press the STOP button on the unit. The total number of tracks of the disc will
be displayed.
Skip track
During playback, press the forward or backward SKIP buttons to skip to the next or previous
tracks.
High-speed music search
During playback, press and hold the forward or backward SKIP buttons to skip/search through
the current track at high speed in forward or backward directions. When the SKIP buttons are
released, normal playback speed will be resumed immediately.
Remark:
If there is no disc in the unit, “NO”
will be indicated on the display.
If the CD cannot be read
,
“NO” will be indicated on the display.