User's Manual

MUW ITS/TPS META SYSTEM
REGULATORY ADDENDUM
2021 Meta System S.p.A. All rights reserved - Without limiting the rights
under copyright, no part of this documentation may be reproduced, stored
in or introduced into a retrieval system, or transmitted in any form or by any
means, or for any purpose, without the express written permission of Meta
System S.p.A. and/or its a liates • Meta System and the Meta System logo are
registered trademarks of Meta System S.p.A. in many countries, including the
U.S. and the E.U. without the express written permission of Meta System S.p.A.
and/or its a liates • Meta System and the Meta System logo are registered
trademarks of Meta System S.p.A. in many countries, including the U.S. and
the E.U.
MUW SENSOR ITS/TPS
FOR VOLUMETRIC PROTECTION
Regulatory Information
All models are designed to be compliant with rules and regulations in locations they are sold and will be labeled as required.
Any changes or modi cations to equipment, not expressly approved by Meta System could void the user’s authority to operate the equipment.
Statement of Agency Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Class B Compliance Statement
The user is cautioned that changes or modi cations not expressly approved by the part responsible for compliance could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit di erent from that to which the receiver is connected.
• Consult the dealer or an experienced radio or television technician for help.
FCC RF Radiation Exposure Statement
Frequency Band Used Maximum  eld strength value Power Supply
12 Vcc
69,5 dBuV/m @ 3mt.5725 – 5875 MHz
CAUTION: Exposure to Radio-Frequency Radiation
To comply with FCC RF exposure compliance requirements, for mobile con gurations, a separation distance of at least
20 cm must be maintained between the antenna of this device and all persons.
This device must not be co-located or operating in conjunction with any other antenna or transmitter.
Installation Instruction Notes
This document is an addendum regulatory included into the installation instructions and user manual provided by the car maker.
All the instruction and the characteristics of the product are in conformity with the statements relating to Part 15.19(a)(3) and/or Part 15.19(a)
(5) and Part 15.21.