User's Manual

• Position the device in a concealed part of the vehicle, inside the
passenger compartment
• To allow the diagnosis and testing operations to be carried out without
difficulty, it is essential to install the device in a position where it can
be easily reached with the cable of the Sat programmer.
• Do not install the device under a mat, where it could be trodden on or
crushed by a load.
• It is advisable to lock the device to a rigid part of the vehicle.
HOW TO POSITION THE DEVICE
HOW TO POSITION THE CRASH SENSOR
GSM
ANTENNA
ONCE YOU HAVE CHOSEN THE POSITION FOR THE ANTENNA, MAKE SURE THAT THE RECEPTION IS GOOD BEFORE FIXING IT IN PLACE:
- CONNECT THE SAT PROGRAMMER AND TEST TO MAKE SURE THAT EVERYTHING WORKS PROPERLY BY MEANS OF THE APPROPRIATE FUNCTION (CONSULT THE RELATIVE MANUAL).
IT MUST NOT BE
VISIBLE OR EASILY
ACCESSIBLE FROM
THE OUTSIDE
DO NOT COVER WITH
PARTS OR METALLIC
PAINTS
CAREFULLY
CLEAN THE
FIXING SURFACE
THE ANTENNA IS RESIN-
COATED AND CAN
THEREFORE BE INSTALLED
ON THE OUTSIDE OF THE
VEHICLE (E.G. UNDER THE
MUDGUARDS, IN A
HEADLIGHT......)
HOW TO CONNECT THE GSM ANTENNA
Fig.6
Fig. 7 Fig. 8 Fig. 9
Fig. 10
FIXING WITH SPACER
Use the supplied spacer to install the sensor on a flat surface, opposite
the fastening tabs (e.g. longitudinal frame members on the PASSENGER’S
SIDE, surfaces BELOW the sensor).
The sensor must NOT be turned. Comply with the position indicated on the
sticker affixed to the side of the sensor.
HOW TO INSERT THE
SPACER
FIXING IN THE VEHICLE
Pay particular attention to
the direction in which
the spacer is inserted.
!
T
O
P
TOP OF
VEHICLE
LEFT SIDE
OF VEHICLE
RIGHT SIDE
OF VEHICLE
FRONT OF
VEHICLE
• Fix the sensor temporarily in place
with the screw.
• Check the position of the sensor by
means of the relative Sat Programmer
menu.
• Fix the sensor permanently in place.
X
Y
X
TOP OF
VEHICLE
LEFT SIDE
OF VEHICLE
RIGHT SIDE
OF VEHICLE
FRONT OF
VEHICLE
X
Y
FRONT
CONNECTION
CRASH SENSOR
CAUTION!
CHECK THE CORRECT
CONNECTION
CLICK!
CLICK!
Fig.5
OK
OK
OK
OK
Y
X
0