User Manual

ENGLISH en
15
Note: the machine will cool more quickly if you
operate it at idling speed.
3. Metabo safety shutdown: the machine has
SHUT DOWN by itself. If the speed suddenly
drops (for example, if the machine suddenly
seizes or kickback occurs), the machine
switches off. Switch off the machine at the
trigger switch (14). Switch it on again and
continue to work as normal. Try to prevent the
machine from seizing.
8.2 Note:
The LED lamp (13) switches off automatically after
a specific time.
Only use original Metabo battery packs and Metabo
accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
Fit accessories securely. If the machine is operated
in a holder: secure the machine well. Loss of control
can cause personal injury.
For a complete range of accessories, see
www.metabo.com or the catalogue.
Repairs to electrical tools must ONLY be
carried out by qualified electricians!
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. See
www.metabo.com for addresses.
You can download a list of spare parts from
www.metabo.com.
Do not allow battery packs to come into contact with
water!
Protect the environment, and do not dispose
of power tools and battery packs with house-
hold waste. Observe national regulations on
separated collection and recycling of disused
machines, packaging and accessories.
Discharge the battery pack in the power tool before
disposal. Prevent the contacts from short-circuiting
(e.g. by protecting them with adhesive tape).
Fig. K. We reserve the right to make technical
improvements.
U = Voltage of battery pack
n
0
=No-load speed
Tightening torque for screwing:
M
1
= Soft screwing application (wood)
M
2
=Pulse torque
M
3
= Hard screwing applications (metal)
M
4
= Adjustable torque
D
1 max
= Max. thread diameter
D
2 max
= Max. drill bit diameter in steel
D
3 max
= Max. drill bit diameter in soft wood
m = Weight (with the smallest battery pack)
G=Spindle thread
D
max
= Chuck clamping range
Measured values determined in conformity with
EN 60745.
Direct current
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on the operating conditions, the
condition of the power tool or the accessories.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Vibration total value
(vector sum of three directions)
determined in accordance with EN 60745:
a
h, ID
= Vibration emission value
(impact drilling in concrete)
a
h, D
= Vibration emission value
(Drilling in metal)
a
h, S
= Vibration emission value (screwing
without impact)
K
h, ...
= Uncertainty (vibration)
Typical A-effective perceived sound levels
:
L
pA
= Sound-pressure level
L
WA
= Acoustic power level
K
pA
, K
WA
=Uncertainty (noise level)
The noise level can exceed 80 dB(A) during
operation.
Wear ear protectors!
9. Accessories
10. Repairs
11. Environmental Protection
12. Technical Data