Operation Manual

Turn the tongue that will be held by the chuck. It should
be of 0.5 mm oversize to ensure a tight fit.
Prepare the workpiece as per section 9.0 of this manual
and mount between the centres.
The max. workpiece length should be approx. 100 mm.
The max. workpiece diameter should not exceed 125%
of the socket chuck diameter.
11 Socket Chucks
Start machine only after the proper seat of the workpiece
has been checked.
- adjust tool rest as required to keep gap between it and
the workpiece as narrow as possible.
23
Turn workpiece by hand to check if it runs clear of the tool
rest and that all levers are fully tightened.
Tap tongue workpiece into chuck. Secure with screws if
workpiece diameter is over 80 mm.